Cell Board replacement
- Disconnect the communication cables to the BMS controller (if applicable)
- Disconnect the communication wires to the adjacent cell boards (if applicable)
- Disconnect the power connections ('B+', 'B-')
- Remove the cell board
- Install a known good cell board
- Reconnect the power connections ('B+', 'B-')
- Reconnect the communication wires to the adjacent cell boards (if applicable)
- Reconnect the communication cables to the BMS controller (if applicable)
- Test the system
StandardProducts/Lithiumate/Service/Repair/Cell Board Replacement (last edited 2009-07-09 01:14:10 by 75-151-94-233-Colorado)
